 ab2G | ab2G Returns reflection coefficient G (gamma) from a and b waves |
| ab2S | ab2S Convert ab wave measurements from measure2Port() to S parameters |
| ab2S_SwitchCorrect | ab2S_SwitchCorrect Convert ab wave measurements from measure2Port() to |
| correct12Term | correct12Term Applies 12-Term Model error correction with |
| correct1Port | correct1Port returns DUT S parameters from 1 port model |
| correct8Term | correct8Term returns DUT S parameters from 8-term error model |
| correctPortExt | correctPortExt Performs correction of S-parameter data from the port-extension model. |
| correctResponse | correctResponse Computes DUT S-parameters by inverting the channel |
| deEmbed | deEmbed De-Embeds an adapter or multiple adapters from a 2-port |
| get12TermModel | get12TermModel Constructs the 12-Term error model (with optional isolation |
| get1PortModel | get1PortModel returns 3 error terms from 1 port calibration |
| get1PortResponseModel | get1PortResponseModel returns a model for the reflection |
| get2PortResponseModel | get2PortResponseModel returns a model for a 2x2 Frequency Response model: |
| get8TermModel | get8TermModel Constructs 8-term model based on measured and listed SOLT |
| get8TermModelUThru | get8TermModelUThru Constructs 8-term model based on measured SOLT and actual |
| getIdealSparams | getIdealSparams Returns S-Parameters of the 'Ideal' Open Short Load |
| getPortExtModel | getPortExtModel Returns error term for the port-extension model. |
| measure1Port | measure1Port makes a,b wave measurement at specified port |
| measure2Port | measure2Port makes 2 port measurement of a and b waves |
| plotCompareDb | Plots comparison of S-parameter objects given in the list S_array. |
| prompt1PortMeasure | prompt1PortMeasure Prompts the user to measure a reflection coefficient |
| prompt1PortSOL | prompt1PortSOL Prompts the user to measure SOL parameters at chosen port (tx) |
| prompt2PortMeasure | prompt2PortMeasure Uses prompt1PortSOL to get SOL measurements at each port, |
| prompt2PortSOLT | prompt2PortSOLT Uses prompt1PortSOL to get SOL measurements at each port, |
| readSnP | readSnP Reads a touchstone file, returning a frequency vector and |
| s2t | S2T Converts a 2x2 S-matrix into a 2x2 T-matrix |
| t2s | T2S Converts a 2x2 T-matrix into a 2x2 S-matrix |
| userMsg | userMsg Prints a msg to the console and waits for user input. Program |
| writeSnP | writeSnP writes S-parameter matrix to touchstone (*.SnP) file |
Master index